Beclate Aquanase


Nasal spray 7.5 ml
scheduling status
S2
registration number
30/21.5.1/0079
What Beclate Aquanase is and what it is used for
Beclate Aquanase is used to treat the symptoms of seasonal allergic rhinitis (stuffy nose, runny nose, sneezing and post-nasal drip), including hayfever, by reducing the swelling and irritation in the nose.
dosage
Adults and children over 12 years of age: One metered dose (50 μg) in each nostril, two to four times a day. Alternately a dosage of two metered doses (100 μg) into each nostril twice daily, can also be used. The total daily recommended dose is 200 μg/nostril/day.
how to take
Beclate Aquanase aqueous nasal spray is for administration through the nasal route only. Before using 1. Shake the bottle gently, then remove the dust cap. 2. Hold the bottle as shown with your forefinger and middle finger on either side of the nozzle and your thumb underneath the bottle. 3. Before using your BECLATE AQUANASE nasal spray for the first time, or if you have not used it for a period of time follow the instructions given below. With the nozzle pointing away from you, press several times as shown until a fine uniform mist comes out of the nozzle. 4. Blow your nose gently. 5. Close one nostril and put the nozzle in the other nostril as shown. Tilt your head slightly forward keeping the nozzle in the upright position. 6. Start to breathe in through your nose and while breathing in press down your fingers once to release a spray. 7. Breathe out through your mouth. Repeat steps 6 and 7 to inhale a second spray. 8. Repeat steps 5, 6 and 7 for the other nostril. After use 9. Wipe the nozzle with a clean cloth and replace the dust cap. NOTE The first time you use BECLATE AQUANASE nasal spray, you may sneeze a few times. This is because the lining of your nose is very sensitive. This is not likely to happen after the first few doses. BECLATE AQUANASE can, at times cause a few side-effects in certain hypersensitive individuals. If you notice any bleeding from your nose or experience any other discomfort, please inform your doctor. Cleansing Your BECLATE AQUANASE Nasal Spray should be cleaned at least once a week. To do this: 1. Push the nozzle upwards to detach from the bottle. 2. Wash the nozzle and dust cap in warm water. Shake off excess water and leave to dry in a warm place. Avoid excessive heat.
What Beclate Aquanase contains
50 μg beclomethasone dipropionate.
other ingredients
Glucose (anhydrous), microcrystalline cellulose, carboxy methyl cellulose sodium, polysorbate 80 (tween 80), benzalkonium chloride 0.01 % m/v, phenyl ethyl alcohol 0.25 % v/v.
Therapeutic classification
Decongestants and other nasal preparations for topical use.
© 2026 SAHPRA. ALL RIGHTS RESERVED