AEROMIDE® NASAL 100
100 mcg (per actuation ) aqueous nasal spray 200
registration number
41/21.5.1/0238
What AEROMIDE® NASAL 100 is and what it is used for
Prophylactic treatment of seasonal and perennial allergic rhinitis.
dosage
Adults and children 12 years of age and older:
The initial dose is 2 actuations (100 μg per actuation) into each nostril in the morning or 1 actuation into each nostril morning and evening. The maximum daily dose should not exceed 400 μg. The maintenance dose may be reduced to the lowest dose that adequately controls symptoms.
how to take
Administration
NB Before using AEROMIDE® NASAL 100 for the first time, shake the bottle, remove the protective cap and spray several times (5 to 10 times) into the air until a uniform mist is obtained (see Fig. 1, on approved Professional and Patient Information Leaflets). The loading effect remains for approximately twenty four hours. If a longer period of time passes before the next dose is taken, the pump will need to be loaded with medicine again. This time it will be sufficient to spray just once into the air.
Instructions for use:
1. Blow your nose.
2. Shake the bottle vigorously.
3. Remove the protective cap.
4. Hold the bottle upright, place your index and middle finger onto the wings of the actuator and support the bottom of the bottle with your thumb. (See Fig. 1, on approved Professional and Patient Information Leaflet).
5. Insert the tip of the actuator into your nostril and spray the number of doses prescribed. (See Fig. 2, on approved Professional and Patient Information Leaflet)
6. Administer the spray into the other nostril in the same way.
7. Wipe the tip of the actuator with a clean tissue after use. Replace the protective cap. Keep the bottle in an upright position.
Cleaning:
Clean the upper plastic parts at least once a week or at any time the medicine is not coming out as it should. Remove the protective cap and lift off the nasal actuator. Wash the plastic parts in warm water. Allow the plastic parts to air dry completely before replacing them. The actuator should not be unblocked with a pin or other sharp object. After cleaning, the pump will need to be loaded with medicine again, before use.
Note:
The full effect of AEROMIDE NASAL 100 spray suspension is not achieved until after a few days.
What AEROMIDE® NASAL 100 contains
Each metered dose contains 100 μg micronised budesonide.
other ingredients
Glucose anhydrous, sodium carboxymethylcellulose/microcrystalline cellulose, polysorbate 80, disodium edetate, hydrochloric acid, purified water and potassium sorbate 0,12 % m/v as preservative.
Therapeutic classification
A 21.5.1 Corticosteroids and Analogues.